Extron electronic Twisted Pair Receiver VTR001 - Manual (Page 15)

VTT001 and VTR001 • Installation
1a Transmitter output connector — A female RJ-45 connector on a
3" pigtail for the VTT001 MAAP and VTT001 AAP models, or
within the VTT001 model. Plug this connector to the UTP cable
going to the receiver.
CAUTION Do not connect the transmitter to a computer data
or telecommunications network.
1b Receiver input connector — A female RJ-45 connector on a 3"
pigtail for the VTR001 MAAP and VTR001 AAP models, or
within the VTR001 model. Plug this connector to the UTP cable
coming from the transmitter.
CAUTION Do not connect the receiver to a computer data or
telecommunications network.
2a Captive screw input power connector — Connect the included
12 VDC external power supply to the 2-pole female direct
insertion captive screw connector. The
VTT001 MAAP, VTT001 AAP, VTR001 AAP,
and VTR001 MAAP have this captive screw
connector.
Power Supply
Output cord
A A
SECTION A–A
RX
9VDC-12VDC 500mA
To verify correct polarity before connection, check the power
supply’s no load output with a voltmeter.
The two power supply leads must be kept separated
while the power supply is plugged into an electrical
outlet. Remove power before wiring.
Do not tin the stripped power supply leads before
inserting them into the captive screw connector. Tinned
leads are not as securely attached as untinned leads and
could slip out.
2-3
+
–
9 - 12VDC P
o
wer