Extron electronic Twisted Pair Receiver VTR001 - Manual (Page 10)

VTT001 and VTR001 • Introduction
Introduction, cont’d Introduction
The Extron VTT001 twisted pair transmitter series and VTR001
twisted pair receiver series provide a system for sending VGA,
RGBHV, and RGBS signals up to 500 feet (150 meters) over
Extron Skew-Free
™ A/V UTP cable. They can also send these
signals over CAT 5/5e/6 UTP cable.
Both transmitter and receiver have remote power capability.
For transmission distances up to 300 feet, the applied power is
required at either the transmitter or the receiver. Greater
distances require power to be applied locally to both transmitter
and receiver.
Depending on the model, both transmitter and receiver
modules may be mounted in a wall, a rack, or in other Extron
products that accept a double-sized MAAP connector panel
(CPM101, CPM200/CPM112R, etc.), or Extron AAP mounting
products; or they may be set on a tabletop. The MAAP models
come in a black or white finish; the AAP models come in black,
white, or gray finish; and the tabletop model comes in a black
finish.
The following table specifies the maximum recommended
transmission distances for the VTT001/VTR001 pair at 60 Hz.
Video Recommended
Resolution Maximum Range
640 x 480 500 feet
800 x 600 400 feet
1024 x 768* 300 feet
1280 x 960* 200 feet
1280 x 1024* 200 feet
1360 x 765 200 feet
1365 x 768 200 feet
1366 x 768 200 feet
1440 x 900 200 feet
1400 x 1050 200 feet
1600 x 1200* 150 feet
* Resolutions marked with an asterisk (*) in the above
table have the same range specification at 75 Hz.
It is possible to exceed the recommended distances.
However, image quality may be reduced.
1-2