Extron electronic Twisted Pair Receiver VTR001 - Manual (Page 18)

VTT001 and VTR001 • Installation
Installation, cont’d
2-6
Pin Wire color
1 White-green Red/V. sync+
2 Green Red/V. sync-
3 White-orange Power
4 Blue Green+
5 White-blue Green-
6 Orange Power
7 White-brown Blue/H. sync+
8 Brown Blue/H. sync-
Wire color
TIA/EIA T-568-A TIA/EIA T-568-B
White-orange
Orange
White-green
Blue
White-blue
Green
White-brown
Brown
Clip Down View
1 2 3 4 5 6 7 8
1 2 3 4 5 6 7 8 RJ-45
Connector
Insert
Twisted
Pair Wires
Pins:
Side View
RGB video signal
Figure 2-5 — RJ-45 pin terminations
For best results, use Extron Skew-Free ™ A/V UTP
cable, available in bulk or in various preterminated
lengths. If necessary, regular CAT 5 cable may be used.
CAT 5e and CAT 6 cables are not recommended.
If you are using Enhanced Skew-Free ™ A/V cable, use
the TIA/EIA T-568-A standard only.
3. Connect the external power supply to the transmitter, the
receiver, or both. Both transmitter and receiver have
remote power capability. For transmission distances up to
300 feet, the applied power is only required at either the
transmitter or the receiver. Greater distances require
power to be applied locally to both transmitter and
receiver. See “Rear Panel Connectors” in this chapter.
4. Connect an output display device to the 15-pin HD video
output connector of the receiver.
5. Connect a RGBHV/RGBS video source to the 15-pin HD
video input connector of the transmitter.
6. Power up the video input and output devices, then apply
power to the power supply and test for the display output.
Adjust the sharpness, if necessary. See “Sharpness
Adjustment” in this chapter. If a problem is encountered,
check all connections before proceeding further.
7. If the previous display test was successful, power off and
disconnect all equipment, detach all cables, and install the
mountable transmitter and/or receiver. See “Mounting”
in this chapter.