Extron electronic Twisted Pair Receiver VTR001 - Manual (Page 24)

VTT001 and VTR001 • Installation
Installation, cont’d
2-12
2. Attach all power and video cables to the rear of the
transmitter/receiver. Power on the transmitter/receiver
now if the external power supply cannot be accessed once
the transmitter/receiver is mounted.
3. Attach the mounting frame (with the attached
transmitter/receiver module(s)) to the wall box, using the
two included mounting screws.
Wall opening
flush with
edge of box
VT T0 01 M AA P
PO WER
Extron
CPM101
Mounting Frame
VIDEO INPUT
VT T0 01 M AA P
Figure 2-8 — Attaching the mounting frame to a wall
box
4. Connect the video input and output devices to the front
faceplates of the transmitter and receiver, respectively.
5. Power on all devices.
Wall bracket mounting
1. Attach the transmitter/receiver module(s) to the
mounting frame with the included #4-40 screws.
2. Attach all power and video cables to the rear of the
transmitter/receiver. Power on the transmitter/receiver
now if the external power supply cannot be accessed once
the transmitter/receiver is mounted.
3. Attach the mounting frame (with the attached
transmitter/receiver module(s)) to the mounting bracket
using the two included mounting screws.