Extron electronic Twisted Pair Receiver VTR001 - Manual (Page 17)

VTT001 and VTR001 • Installation
VTR001 AAP
VTR001 AAP
OUTPUT
VTR001 MAAP VTR001
MAAP
3
2 2
3
2
3
VTR001 AAP
VTR001 AAP
OUTPUT
Figure 2-4 — VTR001 MAAP, VTR001, and VTR001 AAP
front panel views
The VTR001 MAAP, VTR001 AAP, and VTR001
models differ in how they are mounted. The AAP
version has a larger faceplate than the VTR001 MAAP.
2 Receiver video output connector — A female 15-pin HD VGA
connector for all models. Connect a monitor, LCD projector, or
other display device to output an RGBHV or RGBS video signal.
3 Power LED indicator — The LED lights green whenever power
is applied.
Cabling and Setup
To install the VTT001 MAAP, VTT001 AAP, VTT001 models and
the VTR001 MAAP, VTR001 AAP, VTR001 models, follow these
steps:
1. Turn all of the equipment off and, if applicable, disconnect
it from the power source.
2. Connect the RJ-45 connectors of the transmitter and
receiver to either end of the UTP cable. See “Cable
testing” and “Equalizing pair skew” in this chapter.
RJ-45 termination must comply with the TIA/EIA
T-568-A or TIA/EIA T-568-B wiring standards for all
connections, as shown on the following page.
2-5