KEPCO KLR Series Developers Guide - Manual (Page 76)

5-14
KLR-DEV 060713
5.5.3 POWER SUPPLY EVENTS
A Source Power Loss error will cause the Power Supply Event Window (Figure 5-13) to open.
This allows the user an opportunity to correct the error condition and continue or quit the VXI
plug&play application. If this window opens when operating a master/slave configuration, power
to both units must be turned off, then reapplied before pressing either of the two buttons, other-
wise the VXI plug&play application will terminate incorrectly.
FIGURE 5-13. POWER SUPPLY EVENT WINDOW