KEPCO KLR Series Developers Guide - Manual (Page 45)

KLR-DEV 060713
4-3
4.4 USING THE DRIVER FUNCTIONS
The interactive example uses various driver functions of the LabView G driver. The following two
paragraphs details the inputs and outputs of two of typical VI’s used in the interactive example:
KepcoDCPwr Configure Voltage Level.vi (PAR. 4.4.1) and KepcoDCPwr Measure [MSR].vi
(PAR. 4.4.2). An overall block is provided for each function which shows inputs and outputs, fol-
lowed by detailed descriptions of inputs and outputs. A detailed block diagram with associated
text is also provided to show how the function is implemented.
4.4.1 KepcoDCPwr Configure Voltage Level.vi
This VI configures the DC voltage level the power supply is expected to generate.
4.4.1.1 CONNECTOR PANEL
FIGURE 4-1. KepcoDCPwr Configure Voltage Level.vi CONNECTOR PANEL
4.4.1.2 CONTROLS AND INDICATORS
See Table 4-2.
KepcoDCPWR Clear All Lists Clears the list if not executing.
KepcoDCPWR Configure List Loads a specific list from an array of numbers.
KepcoDCPWR Configure List Count Initializes the list count variable
Trigger Functions
KepcoDCPWR Configure Triggered Current Level Establishes the current level upon receipt of a valid trigger
KepcoDCPWR Configure Triggered Voltage Level Establishes the voltage level upon receipt of a valid trigger
KepcoDCPWR Configure Triggered Source Establishes the source for a trigger and arms the trigger sys-
tem.
KepcoDCPWR initiate[TRG] Issue a software trigger to the KLR.
KepcoDCPWR Abort [TRG] Clears the trigger system.
Error and status reporting
KepcoDCPWR Error-Query Provides entry from the error queue of the power supply.
TABLE 4-1. KLR LABVIEW G DRIVER FUNCTIONS (CONTINUED)
Function Name Purpose