KEPCO KLR Series Developers Guide - Manual (Page 54)

4-12
KLR-DEV 060713
4.6.2 SOFTWARE TIMED RAMP EXAMPLE
When the Software Ramp button on the front panel is depressed, the panel shown in Figure 4-8
is displayed. The figure illustrates a current ramp; the voltage ramp panel is similar. The {Power
Supply Mode switch on the front panel (Figure 4-7) determines whether the current ramp or volt-
age ramp is displayed. It is also possible to run this program by selecting either:
KepcoDCPwr Software Timed Ramp Example.vi for a voltage ramp
KepcoDCPwr Current Software Timed Ramp Example.vi for a current ramp.
FIGURE 4-8. SOFTWARE RAMP PANEL, CURRENT RAMP EXAMPLE
These files are located in the kepco DcPWr folder created when the Kepco LabView G driver is
installed and can be executed by selecting File > Run from within LabView. When invoking
either of these files directly, either a network address or a GPIB address must be set before
clicking Start Ramp (this is automatic when executing Software Ramp via the Front Panel.