KEPCO KLP Series Developer's Guide, Rev 1 - Manual (Page 54)

4-12
KLP-DEV 031113
When Start Ramp is clicked, information from the check boxes and # of Cycles is passed to the
example program and used to start ramp execution (see PAR. 4.6.3).
The Error in and Error out boxes are standard error callouts, showing 0 for no error, and an error
code and associated string if there is an error.
FIGURE 4-8. SOFTWARE RAMP PANEL, CURRENT RAMP EXAMPLE
4.6.3 SOFTWARE TIMED RAMP EXECUTION
Clicking the Start Ramp button on the Software Ramp panel causes the Ramp Function Panel
(Figure 4-9 ) to be displayed as the ramp is being generated. Checking the Readback Voltage or
Readback Current checkboxes above the DC VOLTS or DC AMPERES indicators cause the
Voltage and Current indicators to show measured voltage and current vs.commanded values of
voltage and current if unchecked.