KEPCO KLP Series Developer's Guide, Rev 1 - Manual (Page 41)

KLP-DEV 031113
3-19
3.5.2 GETTING A VOLTAGE AND CURRENT READING FROM THE POWER SUPPLY
Figure 3-7 illustrates the use of the IVI-COM driver with LabView to measure the KLP output.
FIGURE 3-7. MEASURING VOLTAGE AND CURRENT USING LABVIEW WITH IVI-COM DRIVER
3.5.3 CHANGING THE VIRTUAL MODEL
The virtual model Vi is very similar to the output setting and measurement examples; it has the
the identical open and close functionality. The middle three blocks set the password, then cause
the voltage limit and the current limit to be applied to the KLP. This is done using the Max Posi-