TA Triumph-Adler P-C3060 MFP User Manual
Page 332
10-13
Troubleshooting > Troubleshooting
Irregular horizontal lines
appear in the image.
―
Select the [System Menu/Counter] key
> [Adjust/Maint.] > [Service Setting] >
[MC] and increase the adjustment value.
Increase the adjustment value 1 level at
a time from the current value. If there is
no improvement after the value is
increased by 1 level, increase by 1 level
again. If there is still no improvement,
return the setting to the original value.
―
The altitude is 1000 m or
higher and irregular
horizontal white lines appear
in the image.
―
Select the [System Menu/Counter] key
> [Adjust/Maint.] > [Service Setting] >
[Altitude Adj.], and set to an elevation
one level higher than the current setting.
―
The altitude is 1000 m or
higher and dots appear in
the image.
―
Select the [System Menu/Counter] key
> [Adjust/Maint.] > [Service Setting] >
[Altitude Adj.], and set to an elevation
one level higher than the current setting.
―
Paper often jams.
Is the paper loaded correctly?
Load the paper correctly.
Is the paper of the supported type? Is it
in good condition?
Remove the paper, turn it over, and
reload it.
Is the paper curled, folded or wrinkled?
Replace the paper with new paper.
Are there any loose scraps or jammed
paper in the machine?
Remove any jammed paper.
2 or more sheets are
overlaps when ejected.
(multi feed)
―
Load the paper correctly.
Printouts are wrinkled.
Is the paper loaded correctly?
Load the paper correctly.
Is the paper damp?
Replace the paper with new paper.
Symptom
Checkpoints
Corrective Actions
Reference
Page