TA Triumph-Adler CX 8682 - Manual (Page 85)

JOB EDITOR
U1 Plot 85
• Rotation:
- The standard orientation of the text is always the reader
direction. Here you can alter the text rotation of in 1° steps.
• Stamp mode:
The standard setting for the type of stamp is always “Opaque“.
There are three possible settings:
- Opaque: The stamp overwrites the area of the drawing
beneath it.
- Transparent: In the “Transparent“ setting the inserted stamp
lies “beneath“ the existing drawing, which means that parts
of the stamp can be overwritten.
- Inverting: It is only the “Inverting“ setting that allows both
the drawing as well as the stamp to be identified in the plot,
because the overlapping areas are shown inverted.
• Stamp placement:
This is where you fix the actual position of the stamp on the
drawing. The frame equates to the drawing, so that you can
choose from the entries for the nine positions from “top“,
“centered“ to “bottom“.
In addition, you can shift this fixed position in the field to the
right of it by a valid size unit. You´ve got to be aware that you
don´t place the stamp outside the drawing because in that case
it won´t be printed or it will be printed only partially. You set the
currently valid size units for U1 Plot in the configuration
program and it is displayed at the bottom of the screen in the
status bar.
• Scale position:
With the “Scale position“ you determine whether the stamp
always retains its position relative to the edge of the drawing
when the size is changed or whether the distance to the edge of
the drawing should be scaled too.