TA Triumph-Adler CX 8682 - Manual (Page 54)

CONFIGURATION
54 U1 Plot
The “No” option has the following consequences for the
print jobs: If you have select expressly a certain roll for your
print job (e. g. Roll 1) and this roll is empty, the plotter won´t
choose another roll. The job will be cancelled and an error
message will be displayed or printed (error page).
But if your job has the setting „auto“ (any roll) the print job
will be printed on another roll which has the same medium
and format.
Use any other media: The printing process will be
continued on another suitable roll. This option has the
following consequences for the print jobs:
If you have select expressly a certain roll for your print job (e.
g. Roll 1) and this roll is empty, the plotter won´t choose
another roll. The job will be cancelled and an error message
will be displayed or a error page will be printed. Whether the
printing process will be continued or not depends on the
settings you have made for the error cases (see below). In
case you have selected the “auto” option (any roll) for the
print job it will be printed on another suitable roll.
• On error: You can choose between three options:
1. The job is halted in case of an error and if the automatic
plot mode is active, this is deactivated.
2. The second option is for the faulty job to be skipped and
for the Autoplot mode to continue.
3. If you select the third option („...print next entries of
current job.”) the faulty entry will be left out and the
following entries will be printed. If there are three or
more than three faulty entries in this job the whole job will
be left out and the next job will be printed.
Extended settings
In this tab you can adjust the response, units and accounting
settings.