TA Triumph-Adler CX 8682 - Manual (Page 61)

JOB HISTORY
U1 Plot 61
program run following installation and numbers through to
10,000,000. It then starts to count from 1,000 again.
This job characteristic cannot be altered.
• Job Name:
This is the name of the print job. It is assigned in U1
PLOTCLIENT.
• Job Owner:
This means the user, who e.g. has prepared the job in a
CLIENT.
• Priority:
The priority is first entered by the user of the job in U1
PLOTCLIENT and shows which print jobs are to be printed in the
job list with priority. The following levels of priority are
available:
→ Normal: If you do not classify jobs with a “high “ priority,
jobs with “normal“ priority are processed quickly.
→ High: This is a high priority level, which the user can assign
in a client. It will be set for urgent jobs.
→ Low: A job with this priority does not wait until all other jobs
have been dealt with, but has three other priority levels
before it, which are processed first.
→ Wait: This is the lowest priority level. This priority shows that
the print job literally “can wait“. This job won´t be printed
automatically. It has to be started manually in the job list.
You can add this priority to a job, for example, if you want to
change the print settings afterwards.
→ Immediately: This is the highest priority level. This priority
can only be set in U1 Plot. The current print job will be
interrupted until the job with priority “immediately” is done.
The following chapter describes how you can alter the priority.
• Job status:
This job characteristic can be used to obtain information about
possible problems or plot errors during the job concerned. The
different status conditions are listed below. Behind each status
condition you can find an explanation and the color which is
shown in the Job list: