TA Triumph-Adler CX 8682 - Manual (Page 76)

JOB EDITOR
76 U1 Plot
• Mirror:
In this area you can set whether the drawing is to be mirrored
or not during plotting. The individual fields mean the following:
OFF: The drawing is not mirrored during plotting.
X: The drawing is mirrored horizontally.
Y: The drawing is mirrored vertically.
XY: The drawing is mirrored about both axes simultaneously;
equates to a 180° rotation.
You usually use these settings if the drawing has been scanned
and saved with a mirror inversion. This is especially important if
a vellum has been scanned with mirror inversion to increase the
contrast.
File Viewer
You can load a drawing in preview window, which is located on
the right-hand side next to the job editor, by selecting it in the
job editor using the mouse. To do this you must activate the
“File Viewer” option in the “View“ menu. You can still change
the view by using the tools in the “View” toolbar. These have
already been explained on Page 38.
“Entry“ area
You can read here, which adjustments can be made for an
individual entry.
If you want to alter the settings for the individual entries i.e. alter
the drawings, you can do this on the two “Specific“ and
“Additional“ tabs, which can be used to make the same
adjustments as described in the “Defaults“ tabs.
To begin altering the settings of an entry you must mark it in the
left-hand entry list. The “Specific“ and “Additional“ tabs are then
also opened and can be edited. If you want to change back to
the job settings or defaults, click once on the “Job“ or “Defaults“
button above the entry list.