TA Triumph-Adler CX 8682 - Manual (Page 107)

PRINT JOB
U1 Plot 107
• Quit Autoplot mode: If the Autoplot mode was activated,
you can deactivate it by clicking on the “Auto” button. The
job order already started is finished. The print function then
stops. You can now make changes to the jobs.
• Cancel creation: If an individual job only is to be
terminated, select the command “Job – Cancel job”.
Delete job
Use one of the following four methods if you want to delete a
job from the list:
• Mark the job in the job list that you want to delete and select
the menu item “Job - Delete“.
• Mark the job in the job list that you want to delete and click
on the following button:
• Mark the job to be deleted with the mouse, click on the
right-hand mouse button and select “Delete“.
• The fourth possible method is to leave all the jobs in the job
list and to update the job list automatically using your
History setting in the configuration program. There you can
set the maximum number of jobs to be included in the list.
The oldest jobs are deleted.
Reload plotter
This command is used if the plotter has failed to initialize. This
can happen e.g. if you have already started U1 Plot, but forgot
to switch on the plotter. In such a case let U1 Plot run, switch on
the plotter and once the plotter has warmed up go to the
“Plotter” menu and select “Reload Plotter“. This reloads the
plotter driver. Renewed plotter loading can also be necessary in