TA Triumph-Adler CX 8682 - Manual (Page 51)

CONFIGURATION
U1 Plot 51
The Help function for the individual CGM format settings can be
opened using the HELP button. This calls up detailed help for all
the buttons and possible settings as provided by Henderson
Software Inc.
Attention: In the “Dialogs“ tab, “Option Dialog“, the
option “Always“ must be activated. This setting
guarantees that the dialog is shown. Do not use the
„Never“ option, because the dialog will never be
shown again respectively it can only be activated again
with huge effort.
Properties
You can adjust further properties of the program using the
“Configuration - Properties“ menu. Each of the possible settings
is described in their own section in the following.
Note: After you have altered the settings, you can use
a test page to check whether the plotter has accepted
the settings. To do this, select the menu command “Job
– Test Page“. You can examine the page produced in
Preview window and then print it.
Spool settings
You can use this tab to alter the settings for the spool processes.
The tab looks like as follows: