Rugged Cams HD Megapixel - Manual (Page 24)

24
2.1.6 DVD-RW installation
 Securely fix DVD-RW by using bracket and screws provided herewith.
 Please do not use any different DVD-RW cables (data cable and power supply cable) other than the ones we provide.
 Otherwise, it may cause damage to the DVD-RW.
 Only one DVD-RW can be used. Mount it at the SATA 3 port. (A and C Type) or SATA 4 port (B, D, E, F, G, H and I type)
CAUTION
Install DVD-RW hard disk after DVR power off. Otherwise, it may cause permanent damage to the hard disk. To turn off DVR, please click (  )
SETUP>SYSTEM>Shutdown. Also, wait for 5 seconds before plugging in power supply again.
2.2 Connector Wiring
2.2.1 Video-In/Out Connections
A, B, C, D and E Type
 Connect a camera to ‘VIDEO IN’.
 If user wishes to link camera input to another device, please connect the camera to ‘LOOP OUT’.
 Assure the ‘VIDEO IN’ and ‘LOOP OUT’ connections are connected properly, not oppositely.
F, G and H Type
 Connect cameras to ‘HD-SDI IN’ to channel 1 to 16.
I Type
 Connect cameras to ‘HD-SDI IN’ to channel 1 and 2.
 Connect cameras to ‘VIDEO IN’ to channel 3 to 16.
 If user wishes to link camera input to another device, please connect the camera to ‘LOOP OUT’
 Assure the ‘VIDEO IN’ and ‘LOOP OUT’ connections are connected properly, not oppositely.
(NOTE)
Only B, D, E, and I Type model supports LOOP OUT connection.
2.2.2 Monitor Connections (Video Out, VGA and Spot)
 Use with CCTV monitor and computer monitor. Please connect the CCTV monitor to ‘VIDEO OUT’(except for G and H
Type), the computer monitor to ‘VGA’, respectively. If necessary, connect another CCTV monitor to ‘SPOT’
 Multi Spot (C and D Type)
- This function supports Multi Channel Display on Spot Monitor
- Connect BNC cable between spot monitor and multi spot port of rear panel.
2.2.3 HDMI connections (C, D, E, F, G, H and I Type)
 Connect HDMI cable to HD out port of rear panel and HDMI port of HD output device.
 Please click ( ) SETUP> DISPLAY> VGA and the following screen will appear.