Rugged Cams HD Megapixel - Manual (Page 191)

191
23. E-Map
23.1 Overview
 The ‘Map Viewer’ program is to display event signals over map images so that users may acknowledge event status with
geographical information.
 Users may perceive event occurrence status with visual notifications on icons over the map image and audible notifications
on speaker system of a PC. By clicking on the camera icons on the map, users may launch ‘Instant Viewer’ window.
 To utilize ‘Map Viewer’ properly, users should configure map before running ‘Map Viewer’ program.
(Please refer to Local setup – E-map in chapter 4.4)
23.2 Controls
 Users can load the Map Viewer which was set up “in Local Setup - E-Map” by clicking right mouse button on the map in the
map list.
 Users can check the information of the device connected E-map in the right side of the Map viewer such as Device status,
name, IP / Domain, the maximum number of Camera, Alarm in / out and Audio.
23.2.1 E-map Camera – Instant Playback
 Users are able to load the instant viewer by clicking the camera icon on the map, change the size of the video and move it
around the screen.
 Full screen mode is available by clicking right mouse button and select “Full screen”.
 Click audio icon to listen to the audio in the site where the audio input is connected.
 Click the alarm out icon to give the signal to the alarm equipment in the site such as siren or buzzer.