RIGOL DP832 - Manual (Page 84)

RIGOL Chapter 2 Front Panel Operations
2-34 DP800 User’s Guide
4. View the analysis results
After the analysis is finished, you can view the analysis results according to your
need.
 Analysis object
Press Object to select "Voltage", "Current", "Power" or "ALL" and the
corresponding analysis results will be displayed at the bottom of the screen.
Note: When "ALL" is selected, you can press the up/down direction key to
switch the current analysis object and view the corresponding analysis
results.
 Display type
The data between the start time and end time in the record file currently
opened will be displayed in figure or table form at the upper side of the
screen.
Press Disp Type continuously to select figure or table display form.
Figure
Display the voltage, current or power (depend on the analysis object
currently selected) corresponding to the current channel of the record file
opened in figure form. Each group of measurement values of each object
are connected in linear interpolation mode, clearly showing the variation
tendency. At the same time, the data corresponding to the "Current Time" is
displayed above the figure.
Tip
 You can view the analysis results of the specified channel by
switching the current channel.
 You can set the analysis object to display the specified type of data
(voltage, current or power) at the upper side of the screen.
 You can view the specified group of data by setting the "Current
Time".