RIGOL DP832 - Manual (Page 54)

RIGOL Chapter 2 Front Panel Operations
2-4 DP800 User’s Guide
Warning
To avoid electric shock, please turn on the output switch after the
output terminals are correctly connected.
CAUTION
When the fan stops, the channel switch can not be turned on;
otherwise, "The fan stops, stop the output!" will be displayed.
8. Check the output mode
In constant voltage output mode, the output mode displayed should be "CV"; if
"CC" is displayed, you can increase the current setting value properly and the
power supply will switch to CV mode automatically.
In addition, DP811 provides an output interface at the rear panel for constant voltage
output. As shown in the figure below, connect the load and the output interface at
the rear panel via the connecting terminal.
Connecting Procedures:
1. Connect the load to the corresponding positions on the connecting terminal
correctly. Pay attention to the polarity when making connections.
2. Insert the connecting terminal into the output interface at the rear panel of the
instrument. Pay attention to the corresponding relations of the connecting
terminal and the output interface.
Note: The output terminals at the front panel and the output interface at the rear
panel cannot be used for output at the same time. You can only select one of them
for output at each time (wherein, the output terminals at the front panel provide
Ouput Interface at
the Rear Panel
Connecting
Terminal