RIGOL DP832A - Manual (Page 96)

RIGOL Chapter 2 Front Panel Operations
2-42 DP800A User’s Guide
Display Setting
Press Display at the front panel to enter the display setting interface. You can set
the screen brightness, contrast, RGB luminance and display mode. Besides, you can
also define the start-up interface.
Brightness
Press Display  Brightness and use the knob or left/right direction key or numeric
keyboard to set the brightness of the screen. The range is from 1% to 100% and the
default is 50%. This setting is stored in the non-volatile memory and will not be
affected by factory reset.
Contrast
Press Display  Contrast and use the knob or left/right direction key or numeric
keyboard to set the contrast of the screen. The range is from 1% to 100% and the
default is 25%. This setting is stored in the non-volatile memory and will not be
affected by factory reset.
RGB Luminance
Press Display  RGB Lum and use the knob or left/right direction key or numeric
keyboard to set the RGB luminance of the screen. The range is from 1% to 100%
and the default is 50%. This setting is stored in the non-volatile memory and will not
be affected by factory reset.
Display Mode
DP800A series power supply supports the following display modes. The default is
normal display mode.
DP831A/DP832A: normal, waveform, dial, classic
DP821A/DP811A: normal, waveform, dial
Press Display  Disp Mode to set the display mode to “Normal”, “Waveform”,
“Dial” or “Classic”. The default is normal display mode. This setting is stored in the
non-volatile memory and will not be affected by factory reset.
 Normal: display the voltage, current and power values of all the channels in
number form.