RIGOL DP832A - Manual (Page 132)

RIGOL Chapter 3 Remote Control
3-8 DP800A User’s Guide
Remote Control via GPIB
1. Connect the device
Use the USB to GPIB interface converter to extend a GPIB interface for the
power supply. Then, connect the power supply to your PC using a GPIB cable.
2. Install the driver of GPIB card
Install the driver of the GPIB card which has been connected to the PC correctly.
3. Set the GPIB address
Set the GPIB address of the power supply according to the description in “To
Set the GPIB Address”.
4. Search for device resource
Start up Ultra Sigma and click to open the window as shown in
the figure (a). Click and the software will search for the GPIB
instrument resource connected to the PC. The instrument resource found will be
displayed at the right side of the window as shown in figure (b). Click
to add the instruemnt resource.
(a)
(b)