Remote control via usb, Remote control via usb -2 – RIGOL DP832A User Manual
Page 126
RIGOL
3-2
DP800A User’s Guide
Remote Control via USB
1. Connect the device
Connect the USB DEVICE interface at the rear panel of DP831A with your PC
using a USB cable.
2. Install the USB driver
This power supply is a USB-TMC device. After you connect the power supply to
the PC and turn both on for the first time (the power supply is automatically
configured to USB interface), the Found New Hardware Wizard as shown in the
figure below is displayed on the PC. Please install the “USB Test and
Measurement Device (IVI)” driver following the directions in the wizard. The
steps are as follows.
1
2
3
4