Riello UPS PowerShield³ - Manual (Page 45)

UPSMON User Manual Advanced UPSMON Configuration • 45
Enable system shutdown if all of
the UPS are supplied from the
batteries
System shutdown parameters for the parallel group can be defined. The shutdown may depend
on the fact that all the UPS within the parallel group are operating in battery mode..
Enable the Ups shutdown after
system shutdown
It is possible to shutdown the groups’ UPS together with the system after the specified delay.
It is possible to save the UPS parallel event configuration, and also possible to load it on another computer without re-inserting the same
configuration, this can be done using the “Load jobs” and “Save jobs”.
To configure the selected actions for the group events there are the next menu:
Action name Action description
Message
In the message text it is possible to add actual values or information which will be displayed
along with the original information, these are as follows:
$NAME The UPS or Group name will be added to the message (See main
parameters dialog box).
$SYSNAME The System name will be added to the message (See main parameters
dialog box).
$SYSLOC The System location will be added to the message (See main parameters
dialog box).
$SHUTTIME The time before shutdown of the local system in seconds.
$SHUTTIME1 The time before shutdown of the local system in the format: hh:mm:ss
$STH, $STM e $STS The three values: the time before the shutdown of the local system in
hours, minutes and seconds.
$REMTIME The remaining UPS battery autonomy.
$REMCAP The remaining UPS battery capacity.
Log event
If selected the event will to be logged into event log file.
ATTENTION: On Windows NT,2000 or XP platforms the events are also logged in the
system Application event log. On UNIX platforms the events are also logged into the
system log (this depends on system configuration: see syslog manual).
Execute file
If selected the Upsagent will execute a specified command file when a selected condition occurs.
Recommendation: Always use the full path name for the file.