RISCO Group Upload/Download software - Manual (Page 8)

Chapter 2: Hardware Installation
Page 5
2. Power up your computer and continue to section 3.2: Installing the Upload/Download software.
PSTN Connection using RAS (Remote Access Service) of the ACM:
PSTN fast remote connection of the ProSYS can be established using a modem located on the ACM
(Advanced Communication Module P/N RP128AA0100A). This connection is used if you want to
establish a backup connection to the ACM IP connection.
The following diagram is the overall system connection using RAS connection:
To establish RAS connection from your computer to the panel:
1. Connect the ACM at the client premises to the PSTN line
Note: The STAND Alone jumper located on the ACM should be set to its default value (no).
2. Modem requirements: Use any modem that supports dialup Internet connection.
GSM/PSTN Upload/Download Fast Remote Connection:
Remote Upload/Download can be performed using the GSM data channel.
Notes:
• Upload / Download via GSM is available only for ProSYS and WisDom panels with an AGM module connected.
• Programming the GSM/GPRS Module can be established with Upload/Download.
• To enable Upload/Download programming over the GSM network the control parameter UD GSM Enable should be enabled
in the control panel. Please refer to the panel manuals for more information regarding this parameter.
The following diagram is the overall system connection using a GSM modem or PSTN:
PC
ACM WITH
MODEM
RP128AB0100A
CONTROL
PANEL
PSTN
TELEPHONE
LINE
MODEM
PC GSM / PSTN
MODEM
AGM
MODULE
CONTROL
PANEL
GSM
NETWORK
4 WIRE
BUS
TELEPHONE
LINE CABLE