RISCO Group Upload/Download software - Manual (Page 7)

Chapter 2: Hardware Installation
Page 4
2. Connect the 4 pin connector to the socket on the Control Panel main board at the client premises or
directly to the 4‐wire bus at any point. (Make sure the panel is in Ready mode and not in Install
mode.)
3. Power up your computer and continue to section 3.2: Installing the Upload/Download software.
Remote:
Modem requirements: Use a Hayes compatible modem: Hayes Optima, US Robotics.
The following diagram is the overall system connection using a modem:
To establish remote connection from your modem to the panel:
1. Connect the modem to your PC and telephone line according to the above diagram.
2. Check the dial tone on your phone line.
3. After hearing the dial tone, hang up and power up your computer and modem and continue to
section 3.2: Installing the Upload/Download software.
TCP/IP Ethernet Connections (ACM):
The following diagram is the overall system connection between the ProSYS security panel and IP
network:
Note: The ACM is compatible with UD software.
To establish IP network connection using the ACM:
1. Connect the ACM to the Ethernet by plugging an appropriate Ethernet cable plug into the RG‐45
connector on the ACM. For detailed information of mounting and connecting the ACM refer to the
ACM manual
Note: When ACM is connected and not in STAND Alone status, you are unable to perform Upload/Download communication
via direct or GSM connection.
PC MODEM
PSTN
TELEPHONE
LINE
CONTROL
PANEL
PC
ACM ProSYS
CONTROL PANEL
IP
4 WIRE
BUS
J1 J2 J3 J4 J5
TERMINAL BLOCKS