RISCO Group Upload/Download software - Manual (Page 21)

Chapter 4: Getting Started
Page 18
4.3.1 Establishing Communication
There are several different types of connections to the panel, follow the correct procedure according to the
physical type of connection you want have:
Direct
To establish direct cable connection from your computer to the panel:
1. Activate the Upload/Download software.
2. In the Client information screen select the Local connection type option (see section 5.1).
3. From the Main menu select Options>System Configuration. The System Configuration dialog box
appears (see section 5.2.2).
4. Enter the relevant Direct Com Port and click OK.
5. Check that communication has been established by setting the time and date (see section 5.5).
Note: The status of the connection appears in the lower bar of your screen. Green means that connection has successfully been
established.
6. To disconnect communication, from the Main menu select Comm>Hang up.
IP Network Connection (ACM)
IP connection can be established for the ProSYS panel using the ACM module.
To establish network connection from your ACM card to the panel:
1. Activate the Upload/Download software.
2. In the Client information screen select the Network connection type and fill in the correct ACM IP
Address (see section 5.1).
Note: It is recommended to check that the ACM IP address on your panelʹs keypad is identical to the IP you enter here.
3. From the Main menu select Installer>Communication>ACM and make sure that the ACM IP address
is the same address you previously filled in the Client information screen. Fill in the relevant fields
(see section 5.3.2).
Note: For detailed information refer to the ACM manual.
4. Check that communication has been established by setting the time and date (see section 5.5).
Note: The status of the connection appears in the lower bar of your screen. Green means that connection has successfully been
established.