RISCO Group Upload/Download software - Manual (Page 35)

Chapter 5: Main Menu Bar Options
Page 32
5.3.1 ProSYS Installer Menu Options
Reporting
Codes: For setting the Reporting codes in the system to the
Monitoring station.
Special
Reporting
Codes: For setting the Special Reporting codes in the
system. The 2 hex digits are converted to 3 decimal
digits (For use with ADEMCO Contact ID and SIA
as additional codes to the built in conversion table
of the panel
Auto SIA Codes: The Auto SIA codes option is accessed.
When this option is selected a message box opens asking you if
you are sure that you want to send Auto SIA Codes Yes/No? If
you do, click Yes. A new message box opens showing Auto SIA
Codes command sent successfully.
Note:
It is recommended to perform Reset Codes before
performing Auto SIA Codes.
Note: It is important to complete the panel configuration before
sending the Auto SIA Codes command. Selecting Auto SIA ID
codes sends a command to the panel to set all report codes
according to the panel configuration.
Warning: Report codes are not updated automatically in the
software. To update, select Upload all. It is important to complete
the panel configuration before sending the Auto SIA Codes .
Auto contact ID
codes: The Auto SIA codes option is accessed.
When this option is selected a message box opens asking you if
you are sure that you want to send Auto Contact ID Codes
Yes/No? If you do, click Yes. A new message box opens showing
Auto Contact ID Codes command sent successfully.
Note:
It is recommended to perform Reset Codes before
performing Auto contact ID codes.
Note: It is important to complete the panel configuration before
sending the Auto Contact ID Codes command. Selecting Auto
Contact ID codes sends a command to the panel to set all report
codes according to the panel configuration.
Warning: Report codes are not updated automatically in the
software. To update – do Upload all. It is important to complete
the panel configuration before sending the Auto Contact ID
command.
06. Report Codes
For setting the reporting
codes in the system, from
the main menu select
Installer>Report Codes
and one of these options:
Note: Most Report Codes have a
corresponding Restore Code which,
following a reported event, restores
the settings to normal. These Codes
are 2‐character codes. The numbers
00 appear as the default in the cell
fields of the codes. To set them,
type 2 characters from 0 to 9 and/or
from A to F. The codes you type
replace the default in the cell field.
Reset Codes: For resetting all the reporting codes for the
Monitoring station.
7. Utility Outputs For setting the Utility outputs in the system, from the main menu
select Installer>Utility Outputs.
8. User Codes For setting the User codes in the system, from the main menu select
Installer>User Codes.
9. WL Button For setting the WL button parameters in the system, from the main
menu select Installer>WL Button.