Precision Digital PD6800 - Manual (Page 19)

PD6800-0L1 Loop-Powered Process Meter Instruction Manual
19
Menu Button
 Press the Menu button to enter Programming Mode.
 Press the Menu button during Programming Mode to return to the previous
menu selections.
 Hold the Menu button for 1.5 seconds at any time to exit Programming Mode
and return to Run Mode.
 Press and hold the Menu button for 3 seconds to access the Advanced Fea-
tures
of the meter.
Right / Reset Button
 Press the Right arrow button to reset the maximum or minimum value while it
is being displayed (see Up / Display Button below).
 Press the Right arrow button to move to the next digit or decimal position
during programming.
 Press Right to go backward through most selection menus.
Up / Display Button
 Press Display when in Run Mode to cycle through displaying the maximum
value, minimum value, and the loop input value in mA. The display will time
out in 12 seconds. Press Display again to resume normal lower display oper-
ation (lower display will read RESUME).
 Press the Up arrow button to scroll forward through the menus, decimal point,
or to increment the value of a digit.
Enter
Button
 Press the Enter button to access a menu or to accept a setting.
 Press Enter to acknowledge alarm (if enabled).