Precision Digital PD6800 - Manual (Page 16)

PD6800-0L1 Loop-Powered Process Meter Instruction Manual
16
SETUP AND PROGRAMMING
There is no need to recalibrate the meter for milliamps
when first received from the factory.
The meter is factory calibrated for milliamps prior to
shipment. The calibration equipment is certified to NIST
standards.
Overview
Setup and programming is done through the infrared through-glass SafeTouch ®
buttons, or using the mechanical buttons when uncovered. There are two slide
switches located on the connector board. One is used to select backlight power (if
equipped) and the other is to lock or unlock the SafeTouch
® Buttons.
After all connections have been completed and verified, connect the ribbon cable to
the display module, fasten the display module to the base, install enclosure cover,
and then apply power.