Xerox WorkCentre 7835ii - Manual (Page 76)

Paper and Media
76 Xerox ® WorkCentre ® 7800/7800i Series Color Multifunction Printer
User Guide
Loading Gloss Paper in Tray 5 (Bypass Tray)
1. Remove all other paper from the tray before loading gloss paper.
2. Load only the amount of paper you plan to use.
3. Load the paper with the glossy side or print side down.
4. Verify the size, type, and color of the paper. Change the selection for any incorrect setting.
5. On the printer touch screen, touch Confirm.
Transparencies
Transparencies can be printed from trays 1–5. For best results, use only recommended Xerox ®
transparencies.
CAUTION: The Xerox Warranty, Service Agreement, or Xerox Total Satisfaction Guarantee does not
cover damage caused by using unsupported paper or specialty media. The Xerox Total Satisfaction
Guarantee is available in the United States and Canada. Coverage could vary outside these areas.
Please contact your local representative for details.
Guidelines for Printing on Transparencies
• Before you load transparencies in the tray, remove all paper.
• Handle transparencies by the edges using both hands. Fingerprints or creases can cause poor print
quality.
• Do not load more than 20 transparencies. Overloading the tray can cause the printer to jam.
• Load Clear or non-strip transparencies face down into Tray 5 (bypass tray) and face up into trays
1-4.
• Do not fan transparencies.
• After you load transparencies, on the printer touch screen, change the paper type to Transparency.
• In the print driver software, for paper type, select Transparency.
• For Trays 1-4, load striped transparencies with the stripe down on the trailing edge (right).
• For Tray 5, load striped transparencies with the stripe up on the trailing edge (left).