MINOURA MT-4000-SF - Manual (Page 3)

3
Insert M5x20 bolt with flat washer
from outside of the larger bracket,
then screw to the alloy roll nut.
(Tightening Torque : 1.5 N.m)
M5x20 Bolt
M5 Flat Washer
Screw M5 Nylon nut to
the bolt with 10mm socket
wrench to fix.
(Tightening Torque : 3 N.m)
!
Installation completed
M5 Nylon Nut
4
Approx.
250mm
Alloy Roll Nut
NOTE: The roll nut is made of soft alloy.
Do not overtighten to avoid the damage on the thread.
M6x15 Bolt
M6 Spring Washer
M6 Flat Washer
M6 Nylon Nut
Quick Release
Skewer
(supplied one)
Replace the front wheel quick release skewer with the
supplied longer one to support the rack.
Connect the fork stay to the mounting bracket.
Loosen the bolt of the fork stay, adjust the rack to be as
horizontal as possible, then tighten the bolt firmly.
Finally, tighten the quick release
skewer with proper process.
!
This rack is made of steel.
If the paint peels away the
rack may rust which can
compromise the steel.
If you find rust, remove
it with sandpaper and
retouch the paint.
Regular maintenance is
recommended, especially
if using near bodies of
water.
When breaking down your
bike for travel or shipping,
make sure to remove the
rack from the front fork.