MINOURA MT-4000-SF - Manual (Page 2)

Required Tools
M4 Hex Wrench, 8mm Socket Wrench (x2), 10mm Socket Wrench, 10mm Spanner
1
Connect the right and left side bodies together with three M5x10 bolts, and install the fork stay on the bracket
on each side slot. You will adjust the stay position later, so you don't need to tighten the bolt so firmly yet.
Right Side
Body
Left Side
Body
M5 Flange Nut
Bolt M5x10
Bolt M6x18
M6 Spring Washer
M6 Flat Washer
M6 Nylon Nut
M6 Flat Washer
Fork
Stay
2
The mounting band should be installed at the point approximately 250mm above from the front wheel axle.
Wind the plastic shim (protector) around the stanchon tube and put the metal band on it.
(The following images show the bracket direction for the right side fork.)
Locate the plastic shim
as the dual rib side is
on your right hand
side.
Attach the larger bracket on
your left hand side. Make sure
the single projection of the
shim is located in the hole on
the bracket.
While holding the
bracket, hook the
smaller bracket together
and wind the stanchon
tube.
Place the smaller bracket
between the dual ribs.
Hold this position for a
while.
Plastic Shim
Bracket
(Large)
Bracket
(Small)
!