MINOURA 971-3 - Manual (Page 4)

- 4 -
How To Mount Bike on 971-3
1
2
3
4
Place the bike on the floor in the same direction you set on Stair Frame.
Place both front and rear tire on Tire Cradles.
While supporting bike with hand, loosen the knob bolt on B.B. Support, and extend the upper support until it touches the
bottom bracket.
After confirming the bike is stably supported that the U-shaped part holds the down-tube and the triange guide is put
between the chain-stays, tighten the knob bolt to hold the position.
5
In the end, shake the bike side to side to confirm the bike is stably supported, then leave from the stand.
Caster Kit (option)
By replacing Foot Adjuster to a caster wheel, you can move 971-3 to anywhere while mounting bikes on it.
Caster Kit contains a reinforcement bar and beam rods to keep the frame solid and stable.
The reinforcement bar will be installed under Pillar-M (473mm).
Caster Wheel
Reinformcement Bar
Beam Rod
Model Variation
971-4
(for 4 bikes)
971-3H
(for 3 bikes)
By combining 971-3 and 971-3H,
you can use them as a one unit
for totally 6 bikes.