MINOURA 971-3 - Manual (Page 2)

1
2
3
!
! To avpoid stain to the floor or carpet, put the supplied
round transparent film on each back of Foot Adjuster.
4
!
5
- 2 -
How To Assemble 971-4
Required Tools
1 x Phillips Screwdriver (#2)
2 x 13mm Socsket Wrench
First of all, check all small parts are correctly prepared.
Parts List
2 x Base Frame 4 x Round Head Screw M5x40
3 x Stair Frame 9 x Hex Head Bolt M8x35
2 x Pillar-S (223mm) 8 x Hex Head Bolt M8x45
2 x Pillar-M (473mm) 2 x Hex Head Bolt M8x60
2 x Joint Frame 15 x Metal Collar (short)
3 x B.B. Support 6 x Metal Collar (long)
6 x Tire Cradle 4 x M5 Spring Washer
4 x Foot Adjuster 21 x M8 Spring Washer
21 x M8 Flat Washer
8 x M8 Nut
Assemble 2 sets of Side Frame.
Connect Pillar S (223mm) and Pillar-M (473mm) with
Joint Frame. Tighten the screw to fix.
Pillar-M
(473mm)
Joint Frame
Pillar-S
(223mm)
M5x40 Screw
M5 Spring Washer
Make sure the direction of Pillar-M.
Joint Frame must be parallel when standing
both pillars.
Assemble Base Frame with each Side Frame.
Install Foot Adjusters on both ends of Base Frame.
Base Frame
Foot Adjuster
Collar (long)
M8 Flat Washer
M8 Spring Washer
Hex Bolt M8x45
Connect both Side Frames with three (3) Stair Frames.
On the 1st level Stair Frame, you use longer M8x60 bolt.
Hex Bolt M8x60
M8 Spring Washer
M8 Flat Washer
Collar (short)
Stair Frame
Collar (long)
M8 Flat Washer
M8 Spring Washer
M8 Nut
Make sure there are two (2) holes on each Stair
Frame for mounting Bottom Bracket Support.
To set the bike heading right, place Stair Frame
to have the holes in left side.
Install Stair Frames on the 2nd and 3rd levels.
Set all frames in the same direction if you wish to set the
bikes in same direction.
Hex Bolt M8x45
M8 Spring Washer
M8 Flat Washer
Collar (short)
Stair Frame