MINOURA EBS-3 - Manual (Page 4)

- 4 -
How To Mount Bike
1
2
3
4
At first, place the front wheel in the right side wheel cradle.
Slide the rear wheel cradle on the Rear Frame to fit the actual bike's wheelbase, then place the rear wheel
in the cradle. It's not necessary to fix the rear cradle position.
While supporting bike with your hand, loosen the backside knob bolt on the Tire Holder then slide it down.
When it reaches the tire, tighten the knob to fix the position.
Finally, shake the bike on EBS-3 slightly
to check if it's supported stable.
Now you can step away.
5 Assemble Ladder Frames onto Side Frames
Assemble Ladder Frame to Side Frame with M8x50 Bolt
(M8x15 on mid level), M8 Spring and Flat Washers,
Collar (Long) and M8 nut in the Parts-Pack #2.
M8x15 Bolt
(mid level)
M8x50 Bolt
(top & low level)
M8 Spring Washer
Collar (Long / 31mm)
M8 Flat Washer
M8 Nut
!
Be sure you use different
size bolt on the mid level.
M8 Spring
Washer
NOTE : This section describes that the bike is set rightward and the front wheel is held by the tire holder.
Now the bike is securely supported at 3 points.