MINOURA BikePit3 User Manual
Page 2
- 2 -
1
2
Front Wheel Hook should be installed alternately to avoid
conflicting the handlebar.
Both hooks must be set at completely opposite side. Narrower
than 180º angle should cause the bikes hit each other.
Install Front Wheel Hook and Rear Wheel Support
to the pillar. Each bike requires one each.
Front Wheel Hook must be positioned at enough
height that the rear tire doesn't touch the floor.
M6x18 Bolt
How To Set Up Pillar
1) Extend pillar, 2) Adjust pillar length, then 3) Install in room.
Look
Push Up
Extend 20mm more
Loosen this
upper bolt
only
Keep tightening
the lower bolt
Lift up
and place
How To Install Hooks
1
2
Loosen the upper bolt, extend Top Pillar, attach to
both ceiling and floor to measure the length, then
tighten the bolt temporally to keep the pillar size.
Remove the pillar and lay down on the floor.
Please be aware both bolts on Pillar Joint are
intentionaly loosened in the package condition.
Your first job is loosening the lower bolt, push
down Pillar Joint until the bracket reaches the
Bottom Pillar end, then tighten the bolt firmly.
4
Loosen the upper bolt again and extend Top Pillar
20mm more, then tighten the bolt firmly.
That is the correct pillar length.
1. Place the upper Rubber Cup against the ceiling then
push up to compress the internal spring.
2. While keeping the spring compressed, slide Bottom
Pillar and align it correctly while bringing it in
contact with the floor.
!
If you see red plastic part in the upper rubber cup when you setup
BikePit, it's the warning sign that the pillar is not extended enough.
Remove from the ceiling, adjust the pillar length properly, and try
to install again.
3
Tightening
Torque:
5 – 8 N.m
5
Use either
M3.5x16 or 25
self tapping screw
To avoid any chance of the pillar falling, hold Top Pillar to the ceiling or the
wall by using the supplied plastic tie. It's not just a recommendation, but your
duty.
Wrap the tie around the pillar just beneath the top rubber cup and wring it, put
the screw in the hole on the tip of the tie, then screw it to the ceiling or wall.
Make sure the screwing area is reinforced solidly. Just the panel will not work.