MINOURA MoZ-Roller - Manual (Page 4)

- 4 -
3
!
The optional "VERGO-TF-Stand" cannot be used with TF-1 because the Rail Bar length of TF-1 is
too short to mount a bike.
Set the white Fork Mount parallel to the Rail Bar in
order to achieve the maximum stability of the bike
during installation. Changing the fork angle should
be done later.
Remove the front wheel from the bike.
Open the quick release skewer lever
to have enough clearance for mounting
the front fork.
Put the front fork genly on the skewer axle.
Make sure the fork is set properly without any
conflict with the projections on the fork bottom.
Tighten the skewer by closing the lever.
It's the correct setting to expect maximum
tightening power that you feel some resistance
on you hand when the lever comes at
45 degrees after passing the parallel
position.
If the skewer is still lose or too tight,
adjust the nut before closing the lever.
This quick release skewer is specially designed for
VERGO-TF to have much wider cam action. You
basically don't need to adjust the nut for the bike
installation and removal.
Options Wheel Holder
An arm for holding the removed
wheel.
Compatible with the previous
VERGO-Excel.
!
Please be advised that too much
bending of Q/R lever may loose
the tightening actually.
Adjust the lever angle to be the
tightest position.