MINOURA MoZ-Roller - Manual (Page 2)

- 2 -
1
!
Schematics
End Base (Gray)
Knob Bolt
T-slot Nut
Plate Nut
Rail Bar (615mm)
Knob Dial (Red)
Fork Mount (White)
Fork Mount Base (Gray)
Quick Release Skewer
(Special for VERGO-TF)
15mm Thru Axle Adapter (Red)
9mm Quick Skewer
Guide Sleeve (Silver)
How To Use VERGO-TF
VERGO-TF is pre-assembled.
The front fork mount is constructed with 3 parts, and the center white Fork Mount has been twisted to minimize
the space in the box. Your first step is setting it at the right position.
Loosen the big red Knob Dial then the white Fork Mount becomes movable. In addition, it will allow to slide the
fork mount on the Rail Bar to change its position. Tighten the knob to securely lock both.
The white Fork Mount is angle adjustgable in 2 positions in leftward and 3 positions in rightward in every 15
degrees.
The function of angle adjustment helps maximizing the cargo space in the car by twising the handlebar.
Loosen the red Knob Dial, slightly lift up the white Fork Mount then it can rotate. Lock in the position where
the projections come into the holes, then tighten the Knob Dial to lock.
Please note the bike will lean or tilt when the handlebar is turned. Stability can become
an issue.