MINOURA RDA2429 User Manual
Page 5
!
When you feel some resistance to tighten the handle more,
stop tightening after two more revolutions. If you see the pil-
lars start open due to the tightening power, it’s normal.
!
Both rubber rollers should contact the rim at same point equally, but it won’t
cause any serious problem even if the rollers are not aligned.
Hold the bike firmly by hand and align the skewer nut to the right side coupling.
While keeping this position, turn the Hub Handle clockwise until the coupling comes into contact
with the skewer nut. Keep tightening.
6
7
Adjust each height of the Mag unit and the Assistant Roller to
fit to your rear wheel perfectly, and then tighten the bolts firmly.
(see Fig. E)
9
Adjust the wheel position side to side as to both
rubber rollers contact the same point of the rim
equally. (see Fig. F)
There is a double-circle indicator on each pulley
arm. This is just for your reference. Indicator is
guide only for refference.
If the pressure of the drive roller against the rim is
too weak, some slippage will occur when pedaling
strongly. To avoid this problem, you should set the
wheel a little leftward.
THE SKEWER NUT PROTECTOR
We strongly recommend you to replace your rear wheel quick release
skewer to the supplied one at all times if your bike is equiped with a quick
release skewer system. This will guarantee a fit with our couplings.
Hole
8
Each rubber roller is made to contact the rim ONLY. Contact with the tire may cause
the tire to burst during use.
The rubber roller is engraved the bottom side to have clearance to fat tire, but make
sure it doesn’t touch the tire at all.
To change the wheel position, loosen the Hub Handle first, loosen the left side knob, then tighten
the Hub Handle. If not enough, repeat this step.
You can use this supplied skewer for the actual ride on the road.
The right side coupling has a black plastic Skewer Nut Protector “Grommet” (F-9). This is for protecting
the skewer nut from damage during use.
If your rear wheel is not designed for the quick release skewer and uses a hub nut system, you should
remove it by inserting a rod or a pen to the hole (see Fig. G) and then lifting up the Grommet.
Indicator
(Fig. G)
(Fig. F)
(Fig. E)
Be sure that the adjustment must be confirmed after tightening the M6x18 bolts.