MINOURA LiveRide LR340 - Manual (Page 3)

- 3 -
3.
How To Setup Your LR340 Trainer
2.
Install the Mag unit and the Roller Pressure Adjust Knob set (MF-3) to the frame.
1.
Replace your rear wheel quick release skewer to the supplied one.
Minoura guarantees the stability only when using the supplied skewer due to the coupling inner
shape.
! If your bike is not equipped with quick release skewer and it's a hub nut type, you
should remove the black plastic Grommet (Skewer Nut Protector) (F-9) from the
right side Coupling (F-1).
Minoura doesn't guarantee the stability if you don't remove the Grommet.
You don't need the supplied quick release skewer if your wheel is a hub nut type.
It's not possible to convert your wheel from the hub nut type to the quick release
skewer type unless replacing the hub.
!
Required Tools: 1 x 10mm Spanner & 1 x M4 Hex Wrench (not supplied)
!
If you have overtightened the
pivot bolt, the Mag unit will not
move smoothly even if you
rotate the knob bolt.
The proper installtion is that
the Mag unit will come down
slowly with its own weight
when you loosen the knob bolt.
Put the acorn spring and the flat washer to
the knob bolt.
Attach the Wing Nut from behind the
bracket on the frame, then screw the knob
bolt into the T-nut through the hole.
(see Fig. B-2)
!
Make sure the acorn shaped spring
direction and the flat washer position
are as shown in Fig. B-2.
Failure will cause difficulty on rotating.
(Fig. B-1)
(Fig. C)
(Fig. B-2)
Once remove the pre-installed pivot bolt and nut
from the Main Frame (see Fig. A).
Attach Mag unit to the bracket on frame, align the
holes, and put through the pivot bolt.
Tighten the pivot bolt with 10mm spanner and M5
hex wrench. (see Fig. B-1)
Knob Bolt
Flat Washer
Spring
Wing Nut
Remove both bolt and nut first
(Fig. A)
Install the rubber cap (M5-2) to each leg.
Fully open both legs and place LR340 on a
flat and level floor. (see Fig. C)
At this moment, make sure all 4 foot are
contacting the floor at once to sit on the
floor stable.