Hotpoint Ariston FP 1005 AB0 - Manual (Page 26)

26
it en
6. Add fruit or vegetables through the feeding tube
and only gently push forward with the pusher. Cut
beforehand if necessary.
7. After processing, set the rotary switch briefly to
high speed and leave the appliance running until
all the fruit pulp has been squeezed out.
Maximum processing quantity: 250g fruit or
vegetables.
Use THe cITRUs PRess
ATTAcHMeNT (e)
Please read “Important information and
safeguards” paragraph before using.
be sure the unit is Off and the cord is un-
plugged before use.
The pressure cone can not be removed from the
juice.
Halve the food/fruit in advance.
let unit do the work, heavy pressure will not
speed operation. do not use the processor con-
tinuously for more than 30 minutes at a time, allow
a rest period of 1 minute between working cycles.
1. Place the Bowl onto the Base.
2. Ensure the Drive shaft is placed in position.
3. screw on the Citrus Press as far as possible in an
anticlockwise direction.
4. To extract juice from the fruit, set the rotary switch
to low speed and press the fruit onto the pressing
zone.
do not exceed the max liquid level in the
bowl. empty the bowl soon.
Use THe bleNdeR
ATTAcHMeNT (f)
Please read “Important information and
safeguards” paragraph before using.
Before first use, wash all parts except the
unit base: the Measuring cup, lid, jug
assembly (the jug assembly includes jug, blade
assembly, gasket and jug base). The jug assem-
bly is non- decomposable.
blades are sharp. Handle carefully. Never place
blender motor base in water or other liquids.
1. Place the jug assembly onto the Base. Put down
the jug assembly until it is correctly placed on the
Base, snap the jug assembly handle and rotate it
anticlockwise until it is fully locked on the Base.
2. Place the food to be blended into the jug.
3. Put the lid on the jug and rotate it anticlockwise
till lock position. Be sure the measuring cup is in
place.
4. Ensure the knob is on “OFF”. Plug the cord into a
standard electrical outlet.
5. For best results when crushing ice, use “PULsE”.
To activate it, rotate it anticlockwise until it is on
“PULsE”; to stop crushing, release the knob.
6. If you want to add ingredients while the blender is
on, remove the measuring cup and feed through
the lid opening.
7. When finished blending, rotate the knob until it is
on the “OFF” position.
There is only one position for the jug
assembly to be locked onto the base. The
unit won’t operate if the jug assembly is not
correctly placed onto the base.
Tips and Techniques
• To avoid damage, do not process deep-frozen
ingredients (except ice cubes). Do not operate
when empty.
• Cut food into small pieces, about 2 in. (5 cm) be-
fore adding to the blender. To chop, grate or pre-
pare fruit smoothies using fresh or frozen fruit, cut
foods into 3/4 in. (2 cm.) pieces.
• For best circulation of foods that are to be blended
with some liquid, pour the liquid into the jug first,
then add solids.
• Following items should never be placed in the unit
as they may cause damage: bones, large pieces
of solid frozen foods, or tough foods such as tur-
nips.
• To crush ice, fill blender jug half-full with cold wa-
ter. Add about 2 cups of ice cubes. Hold one hand
firmly on the lid and rotate the knob on pulse posi-
tion. If more ice is needed, remove the cap and
add cubes one by one through the hole in the lid.
DO NOT CRUsH ICE WITHOUT LIQUID. Failure
to follow these directions can result in damage
to the blades, jug, blender, and possibly result in
personal injury.
Use THe MIllINg cUP
ATTAcHMeNT (g)
Use the milling cup for herbs, nuts and coffee
beans.
1. To open the cup, screw counter-clockwise the
blade unit (yy).