beautypg.com

Extron electronic IN1404XT User Manual

Page 69

background image

4-13

IN1404XT Video Scaler and Switcher • Programmer’s Guide

Command/Response Table for RS-232 Commands (Cont’d)

Command

ASCII Command

Response

Additional description

(host to scaler)

(scaler to host)

Front panel buttons

Menu

button

[MENU]

[OK]

The same as pushing the front
panel Menu button. The on-
screen display shows the menu
system.

Left

button

[LEFT]

[OK]

The same as pushing the front
panel button.

Up

button

[UP]

[OK]

The same as pushing the front
panel (Menu , not volume ).

Down

button

[DOWN]

[OK]

The same as pushing the front
panel (Menu , not volume ).

Right

button

[RIGHT]

[OK]

The same as pushing the front
panel button.

Enter

button

[ENTER]

[OK]

The same as pushing the front
panel Enter button. Any
highlighted or changed on-
screen display parameters are
saved.

The rest of the RS-232 commands are a complex set of adjustments to optimize
the scaler for non-standard video inputs. Most users will not encounter such
signals. Extron recommends that only knowledgeable and qualified video
technicians make changes to these settings.

Active area

The active pixels and total pixels adjustments are interactive. Setting one of
these variables may require adjusting the other.

Set

a specific active pixel value

[AP

X29

]

[OK]

Specify the active pixels
adjustment.

Increment active pixels

value

[AP+]

[OK]

Increase the active pixels setting
by one.

Decrement active pixels

value

[AP-]

[OK]

Decrease the active pixels setting
by one.

Set

active pixels value to default [AP@]

[OK]

Reset the active pixels setting to
its factory default (9).

View

the active pixels value

[AP?]

[

X29

]

Show the active pixels setting.

Set

a specific active line value

[BV

X30

]

[OK]

Specify the active lines
adjustment.

Increment active lines

value

[BV+]

[OK]

Increase the active lines setting
by one.

Decrement active lines

value

[BV-]

[OK]

Decrease the active lines setting
by one.

Set

active lines value to default

[BV@]

[OK]

Reset the active lines setting to
its factory default (9).

View

the active lines value

[BV?]

[

X30

]

Show the active lines setting.

Blanking

Set

a specific H blanking value

[BH

X31

]

[OK]

Specify the active pixels
adjustment.

Increment H blanking

value

[BH+]

[OK]

Increase the horizontal blanking
setting by one.

Decrement H blanking

value

[BH-]

[OK]

Decrease the horizontal blanking
setting by one.