Extron electronic IN1404XT - Manual (Page 14)

Installation, cont’d
IN1404XT Video Scaler and Switcher • Installation 2-2
Installation
Installation Overview
To install and set up an IN1404XT video scaler and switcher for operation, perform
the following steps:
1 Disconnect power from all of the equipment, including the video and audio
source(s), and the devices that will receive the output video and audio signals.
Ensure the power switch on the scaler is off.
2 Rack mount the scaler if desired. See Mounting the Scaler in this chapter.
3 Connect the video and audio input cables. See Input connections in this
chapter.
4 Connect the standard video and audio output cables. See Standard output
connections in this chapter.
5 If desired, connect the TP cable between the scaler and an optional VTR001CM
TP receiver and connect the output cables from the TP receiver to the display.
See TP output connection in this chapter and refer to the VTT001CM and
VTR001CM - Twisted Pair Transmitter and Receiver manual, part # 68-760-01.
6 If desired, connect the RS-232 cable. See RS-232 connection in this chapter.
7 Connect the AC power cable. See Power connection in this chapter. Turn on
the sources, video and audio destinations, and the scaler.
6 Configure the scaler’s inputs and configure the output for the optimum
image. See chapter 3, Operation and chapter 4, Programmer’s Guide.
Mounting the Scaler
The scaler includes four installed rubber feet. If you are going to rack mount the
scaler, mount it before cabling it (see Rack mounting, below). The IN1404XT is
exactly 1U high without the rubber feet; if you plan to rack mount the scaler with
other equipment directly underneath it, the feet must be removed.
Rack mounting
Rack mount the scaler as follows:
1 . Remove the three enclosure screws on one side of the scaler (figure 2-1).
Rack-mount
Bracket
Figure 2-1 — Mounting the scaler
n
ns