Extron electronic IN1404XT - Manual (Page 64)

Programmer’s Guide, cont’d
IN1404XT Video Scaler and Switcher • Programmer’s Guide 4-8
Command/Response Table for RS-232 Commands (Cont’d)
Command ASCII Command Response Additional description
(host to scaler) (scaler to host)
Set blue gain value to default [BLU@] [OK] Reset the blue gain setting to its
factory default (128).
View the blue gain value [BLU?] [ X8 ] Show the blue gain setting.
Color saturation
1 . Color saturation adjustments are available only for NTSC interlaced
component video, S-video, and composite video inputs only.
2 . No video adjustments are available for the input 4 video signal when it is
configured as passive (unscaled).
Set a specific color saturation value [SAT X8 ] [OK] Specify the color saturation
adjustment.
Increment color saturation value [SAT+] [OK] Increase the color saturation
setting by one.
Decrement color saturation value [SAT-] [OK] Decrease the color saturation
setting by one.
Set color saturation value to default [SAT@] [OK] Reset the color saturation setting
to its factory default (128).
View the color saturation value [SAT?] [ X8 ] Show the color saturation setting.
Hue
1 . Hue adjustments are available only for NTSC interlaced component
video, S-video, and composite video inputs only.
2 . No video adjustments are available for the input 4 video signal when it is
configured as passive (unscaled).
Set a specific hue value [HUE X8 ] [OK] Specify the hue adjustment.
Increment hue value [HUE+] [OK] Increase the hue setting by one.
Decrement hue value [HUE-] [OK] Decrease the hue setting by one.
Set hue value to default [HUE@] [OK] Reset the hue setting to its
factory default (128).
View the hue value [HUE?] [ X8 ] Show the hue setting.
Sharpness
1 . Sharpness adjustments are available only for interlaced component video,
S-video, and composite video inputs only.
2 . No video adjustments are available for the input 4 video signal when it is
configured as passive (unscaled).
Set a specific sharpness value [SHP X9 ] [OK] Specify the sharpness
adjustment.
Increment sharpness value [SHP+] [OK] Increase the sharpness setting by
one.
Decrement sharpness value [SHP-] [OK] Decrease the sharpness setting
by one.
Set sharpness value to default [SHP@] [OK] Reset the sharpness setting to its
factory default (3).
View the sharpness value [SHP?] [ X9 ] Show the sharpness setting.