Extron electronic IN1404XT User Manual
Page 67
4-11
IN1404XT Video Scaler and Switcher • Programmer’s Guide
Command/Response Table for RS-232 Commands (Cont’d)
Command
ASCII Command
Response
Additional description
(host to scaler)
(scaler to host)
Pixel phase (continued)
View
the sampling value
[PHS?]
[
X19
]
Show the pixel sampling phase.
Freeze
Video freeze on
[FRZ1]
[OK]
Freeze the video output.
Video freeze off
[FRZ0]
[OK]
Unfreeze.
Toggle
video freeze
[FRZ]
[OK]
Change the state of video freeze
(off to on or on to off).
View freeze
[FRZ?]
[
X2
]
View the status of the freeze
setting.
Memory preset
Save
preset
[MSAV
X20
]
[OK]
Save the video, balance, and
input settings as preset
X20
.
Recall
preset
[MRCL
X20
]
[OK]
Recall preset
X20
settings.
Reset
preset
[MRST
X20
]
[OK]
Erase preset
X20
settings.
Volume
Set
volume
[VOL
X21
]
[OK]
Set volume for the selected input.
Increment
level
[VOL+]
[OK]
Increase balance level for the
selected input.
Decrement
level
[VOL-]
[OK]
Decrease volume level for the
selected input.
Set
volume level to default
[VOL@]
[OK]
Set the volume to the default.
View
volume level
[VOL?]
[
X21
]
View the volume level for the
selected input.
Bass
Set
bass
[BAS
X22
]
[OK]
Set bass for the selected input.
Increment
level
[BAS+]
[OK]
Increase bass level for the
selected input.
Decrement
level
[BAS-]
[OK]
Decrease bass level for the
selected input.
Set
bass level to default
[BAS@]
[OK]
Set the input bass to the default.
View
bass level
[BAS?]
[
X22
]
View the bass level for the
selected input.
Treble
Set
treble
[TRE
X23
]
[OK]
Set treble for the selected input.
Increment
level
[TRE+]
[OK]
Increase treble level for the
selected input.
Decrement
level
[TRE-]
[OK]
Decrease treble level for the
selected input.
Set
treble level to default
[TRE@]
[OK]
Set the input treble to the default.
View
treble level
[TRE?]
[
X23
]
View the treble level for the
selected input.
Balance
Set
balance
[BAL
X24
]
[OK]
Set balance for the selected input.
Increase
balance right
[BALR]
[OK]
Move balance right for the
selected input.
Increase
balance left
[BALL]
[OK]
Move balance left for the selected
input.
Set
balance level to default (center) [BAL@]
[OK]
Set the input balance to the
center.