Magnum Energy MMS-E Series - Manual (Page 11)

© 2011 Magnum Energy, Inc.
Figure 1-2, Top and Left Side Features
4
Positive DC Terminal (red) - the inverter’s connection to
the positive terminal on the battery bank.
5
Input Circuit Breaker - this circuit breaker protects the
unit’s internal wiring and pass-thru relay.
6
Output Circuit Breaker - this circuit breaker provides
another layer of overload protection. This is not a branch
circuit-rated breaker. Separate AC output breakers may be
required on the output.
7
Mounting Flanges (x4) - secures the inverter to shelf/
wall.
8
AC Wiring Compartment - provides access for all AC input
and output connections on the inverter.
9
AC Output Connection - AC knockout for hardwiring AC
output.
10
AC Input Connection - a strain relief clamp for hardwiring
AC input.
11
DC Ground Terminal - this connection is used to tie the
exposed chassis of the inverter to the DC grounding system.
This terminal accepts CU/AL conductors from 2.08 mm² to
13.29 mm² (#14 AWG to #6 AWG).
4
1.0 Introduction
1 2
3
4
5
6
7
8
10
9
11