KACO Powador-proLOG - Manual (Page 6)

Operating Instructions Powador-proLOG_EN Page 7
3 Notes on installation
and operation
3.1 Intended use
The Powador-proLOG is used for system monitoring of a pho-
tovoltaic system.
It records the currents, voltages, temperatures, power and
yields of every individual inverter, as well as the values of the
externally connected sensors.
The Powador-proLOG is built according to the state of the art
and recognised safety rules. Nevertheless, improper use may
cause hazards for the operators or result in damage to the
units.
Any other or additional use of the device is deemed improper.
The manufacturer/supplier is not liable for damage caused by
such use. Damage caused by improper use is at the sole risk
of the operator.
Intended use also includes adherence to the operating instruc-
tions.
3.2 Factory warranty and liability
KACO new energy GmbH grants a warranty of two years on
the Powador-proLOG starting from the date of shipment by
KACO new energy GmbH.
During this time, KACO new energy GmbH guarantees the
proper function of the units and to undertake repairs at the
factory free of charge in the event of a defect for which we
are responsible.
Contact your specialty dealer if your unit exhibits a defect or
fault during the warranty period.
Warranty claims are excluded in the following cases:
– Use of the units in ways not intended
– Improper installation or installation that does not comply
with standards
– Improper operation
– Operating the unit with defective protective equipment
– Unauthorised modifi cations to the units or
repair attempts
– Infl uence of foreign objects or force majeure (lightning,
overvoltage, severe weather, fi re)
– Failure to observe the relevant safety regulations
– Transport damage
All warranty claims must be handled at the premises of KACO
new energy GmbH. Where possible, the unit must be returned
in its original or equivalent packaging. The costs for these ser-
vices cannot be borne by KACO new energy GmbH.
KACO new energy GmbH will only perform warranty services
if the defective unit is returned to KACO new energy GmbH
together with a copy of the invoice which was issued to the
user by the dealer. The name plate on the unit must be fully
legible. If these requirements are not fulfi lled, KACO new
energy GmbH reserves the right to deny warranty services.
3.3 Service
Starting with the product development phase, we place a
great deal of importance on ensuring the quality and longev-
ity of our data loggers.
However, in spite of all quality assurance measures,
faults may occur in rare cases. In such cases, KACO new
energy GmbH will provide you with the maximum pos-
sible support. KACO new energy GmbH will make every
effort to remedy such faults in an expeditious manner
and with a minimum of bureaucracy.
In such cases, please contact our service department directly.
Telephone: +49(0)7132-3818-680
e-Mail [email protected]
So that your enquiry can be dealt with more quickly, please
always have the serial number (A) and hardware serial number
(B) of your data logger to hand. Both numbers can be found
on the name plate on the left-hand side of the housing (see
fi gure below).
S e c t i o n 3 · N o t e s o n I n s t a l l a t i o n a n d O p e r a t i o n
A
B