KACO Powador-proLOG - Manual (Page 22)

Operating Instructions Powador-proLOG_EN Page 23
▲ Alarms/Faults
→ Communication
- Modem fault
A fault occurred while establishing the modem
connection
→ System error:
- System fi le is missing
A fi le that is needed by the system is missing.
→ System alarms
-Alarm list
A list of the system alarms that were triggered.
- Reset local alarms
Reset the local alarm at D0.
→ Hardware
- AI/DI fault
Analogue/digital input fault
- OCS does not respond
No reply from the current sensor
- Inverter does not respond
No reply from the inverter
Factory settings:
Network: IP address: 192.168.100.50
Subnet mask: 255.255.255.0
Modem: IP address: 192.168.200.1
Remote IP address: 192.168.200.51
Subnet mask: 255.255.255.255
Analogue :Call acceptance active
ISDN: MSN deleted
GSM: PIN code is 4321
S e c t i o n 6 · S t a r t - u p
6.5 Powador-proLOG XL with GSM/GPRS
modem
6.5.1 General information
To ensure optimum operation of the Powador-proLOG, we rec-
ommend that you take advantage of the agreement that we
offer. The costs for this agreement are passed on one to one.
The alternatively used GSM/GPRS data card must have the fol-
lowing properties:
– You should be able to call the data card using an analogue
modem. For this reason, the card’s data telephone number
is required. You usually receive another number for data
traffi c from your grid operator.
– You must be able to send e-mail (with attachments).
– The transfer rate is 9.6 kBit/s.
– The card does not require storage space.
– The data volume is approx. 100 kB per day, assuming the
data is sent once per day by e-mail (without alarms).
– A CSD (Circuit Switched Data) data service must be acti-
vated.
6.5.2 Inserting a SIM card
IMPORTANT
If you use a different contract, KACO new energy will not
be able to provide you with support due to recurring prob-
lems with the various network providers.
ATTENTION
Be sure to ground yourself before touching any of the
electronic components.